alt Hacker NewsDespite being aware of its existence, I stuck with OpenSCAD out of habit. Only last week did I read through the documentation, and feel strongly that I've been missing out… it seems to solve all of my gripes with OpenSCAD. I'm excited to try it out!
Replies
plumbees • today at 3:46 PM
I've been wanting to get into OpenScad. Wondering what you've identified as an issue. I dabbled a little and I think I remember wishing it was more object oriented to make it a bit easier to make reusable adjustable pieces and I had found a python library that does openscad conversions; Wondering what gripes it solves for you.
➕ show 2 replies
Mainly OpenSCAD is not a BRep modeling tool! It is not on the same level of power as CAD tools with a BRep kernel and this especially shows when you want to do a fillet over an arbitrary edge. Unfortunately these kernels are hard to make and integrate and I only know of two open-source BRep kernels out there: OpenCASCADE (used by FreeCAD and build123) and truck (not sure what the status of it is).