Building something useful in a circuit design using off-the-shelf ICs and components doesn't require a very deep understanding of the theoretical basis for why it works. There's really no need to be gated by thinking that overly complex mathematics and physics concepts must be fully understood before building. Most electronic parts datasheets have example circuits and layouts that can be followed to get a working design. A lot of progress can be made just by reading the datasheet, learning how to use a tool like fusion 360 electronics, kicad, etc., to connect the parts in a schematic, lay them out on a board, generate a gerber, send it to a china PCB shop like PCBway, get the pcb, assemble/solder the parts onto it, some cases may need some firmware which AI can do a lot now, finally fire it up and see if it works. Very few calculations or theoretical knowledge needed, outside of Ohms law.