alt Hacker NewsI do wonder how long the electronics, motor and little (plastic) gears in the drill would last with this. Especially since I'd suspect that it's designed for intermittent use, where it has time to cool down between each screw / hole drilling that you'd do normally. If you drive 2 miles in one go, that'll be a lot of heat that doesn't have time go anywhere.
Somehow I'd suspect that it won't last all that long...
Replies
lisp2240 • today at 8:31 PM
Drills are used sporadically. If a drill was used intermittently it would be on most of the time and occasionally off.
➕ show 2 replies
I suspect there's very little power needed once you're up to speed and cruising, but constant stop-and-go and long uphill runs will certainly cause it to overheat.
It's brushless so brush wear isn't a problem, but these motors are air-cooled and will actually be cooler at high speed, low-demand. Lugging it up a hill would be a worst case.