If you want to save fewer bucks, get to zero plastic and get better espresso, you can buy one of these and a burr grinder:

https://flairespresso.com/products/the-flair-classic

I've had one for about a decade. It reliably produces better espresso than >99% of Bay Area coffee shops. (>95% if you exclude national chains).

If I were buying one today, I'd toss the flow control head, silicon sleeve on the cylinder and the pressure gauge, but those come with it for free now, so to each their own, I guess.

The trick is to boil the stainless steel cylinder in your kettle (PID at sea level, conventional above ~ 2000 ft elevation) with the water so that you get the temperature dialed in within a degree C or so, like a conventional (lead-filled, unlike the flair) Italian machine. I use a pair of tongs to pick up the stainless steel cylinder, so I don't need the sleeve. (Check the boiling point of water at your elevation -- unlike a steam machine, this can't exceed that temperature, so stuff might start to run kinda cool at 3000 ft or so).

Flair doesn't sell a "true" classic anymore, but I bet they could get the bare bones variant I use to < $100 if they tried. Maybe someone else will when any patents run out. My only other complaint is that the two-in-one bottomless porta-filter I have runs the espresso across plastic when in non-bottomless mode.

Note that the thing I linked has a plastic plunger. They make a stainless steel one as an upgrade. At that point, you're down to one silcone o-ring in the water / coffee path. Everything else is stainless, so no lead. The next thing to worry about is nickel, but that only matters if you're allergic. I used to use the SS plunger, but then you need to boil it too if you want to dial in the water temperature.