logoalt Hacker News

drfloyd51 • yesterday at 5:29 PM • 2 replies • view on HN

Just adding a note to future readers: frequency is correctly measured dip to dip or top to top. Or every second time a particular value is reached.


Replies

ky3 • yesterday at 9:47 PM

> Or every second time a particular value is reached.

The value is waving, so a complete cycle is when it got back to where it started: that is, not just its value but its _direction of change_ is also the same.

(A value waving in 3D could coincide with its start value multiple times before it completes a whole cycle.)

jrmg • yesterday at 5:59 PM

The difficulty here is that it's 480Hz top-to-top, but there are two definitions of dip-to-dip depending on if you count every 'dip' from 100% (480Hz), or just the ones that reach the lowest voltage ⃰ (240Hz).

⃰ ⃰(brightness - presumably the test setup is an LDR or something?)

➕ show 1 reply