It's very unfortunate that our electric codes are based primarily on incandescent lighting. If we were designing electricity from scratch, we'd probably be set up with 240v 3 phase AC for big loads (ovens, heaters etc) and 48v DC for lighting and most electronics. Requiring every device to have its own rectifier is a lot less efficient than putting a single good rectifier in a central location.
> Requiring every device to have its own rectifier is a lot less efficient than putting a single good rectifier in a central location.
Is it, though?
You'd have to deal with additional wiring losses due to the lower voltage between the central rectifier and the devices, and the various individual devices would still need their own step-down converters to turn that 48VDC into something they can actually use.
On top of that: the central rectifier would have to be sized for peak load, while in reality the vast majority of the time it would be running at only a fraction of that. That's not exactly ideal for efficient operation. Individual power supplies can be designed specifically for a single device and operate at its sweet spot most of the time.
DC doesn't buy you that much for electronics. You still need to do DC-DC conversion to 12V or 5/3V for the electronics itself.
And to avoid ground loops, you also need fully isolated DC-DC converters. So you end up with the same power supply architecture as for AC-DC, saving only on buffer capacitors.
As an experiment, I converted my homelab to 48V DC to operate from the battery directly after my attempts at making a UPS failed. It works, but it's barely more efficient than doing a double-conversion.
I'm now redoing lighting in my house, and _there_ the DC power makes a lot of sense. I'm planning to use commercial-grade DALI, with tunable white setpoint. It uses true DC dimming, so there's no flicker whatsoever.
Fine. So we've got serious 3-phase for big loads, and 48VDC for everything else.
Which circuit does the blender connect to, or the kettle? The air fryer? The coffee machine?
How do I power a space heater to warm up a chilly room for the baby on a particularly cold and windy night?
Where does the window air conditioner connect that I need because my landlord is cheap and there's an intolerable heatwave?
The audio system? The guitar amp? The gaming rig? The vacuum cleaner?
I guess we plug that stuff into 3-phase outlets, which we'll need to have everywhere -- right? Fine.
---
So we've got other stuff, too, that's a little lighter. Phones, laptops. Lights. Stuff. That can all be made to convert 48VDC down to whatever it needs internally, but that conversion requires electronics that are local to the device. We haven't eliminated that at all.
But sure: It runs on 48VDC that is sourced from some manner of manner of central power supply. Neat, I guess?
---
But why?
It sounds like all we've really accomplished here is adding more wires, and more complexity.
I'm struggling to figure out how any of this is presents any meaningful advantage.
(Oh, I know! Let's keep our existing single-phase circuits, and add both 3-phase AC and 48VDC! Whooo boy! Now we've got a real clustefuck cookin'!)
Manufacturers are selling DC bulb systems these days. Unfortunately, the ones I've seen sell the accompanying rectifiers (which need maybe $50-100 of power electronics inside) for multiple thousands of dollars, and they're DRM locked to the more expensive bulbs by proprietary protocols.
I find the inefficiencies of the old system more manageable.
DC mains, even at low voltage (which also means a higher current capability for the same amount of power, and thus thicker cables and/or higher resistive loss), is more dangerous than AC because it doesn't stop flowing; AC goes to 0 twice a cycle, so arcs have a chance to extinguish. DC switchgear needs special provisions for breaking arcs, such as "blowout coils".
Some early electrical installations, as in late 19th/early 20th century, used DC. Most have disappeared, with the exception of some surviving early elevators and perhaps some huge industrial motors, converted to running from a rectifier.