Even many expensive LEDs seem to have some sort of flicker, I can only guess that they're cheaping out on some capacitor and enough of the rectification ripple leaks through. We had the technology for high frequency output in ballasts with CFLs, if they can do that then surely non-flickering LED bulbs should be a solved issue
There are four general categories of LED luminaire:
- Driverless, common as 120V chip-on-board light sources and as 120V strips. These are basically made out of diodes and resistors. They are awful. There are advanced designs that are slightly less awful.
- Self-contained devices with little driver ICs. You’ll find these in screw-in lamps and some integrated fixtures. They range from surprisingly good to awful, both in terms of flicker and dining performance. They have hazardous voltages inside (no isolation), so they’re essentially always supplied as a unit with 120V input. There are also 12VAC devices like this.
- Constant current light source (typically a few hundred mA at a voltage around 15-56V). The light source may be literally just an LED. The driver will be remote, possibly inside the same fixture, and the output may be NEC Class 2 or otherwise quite safe. These are the best, especially with a good driver. Flicker may be essentially zero.
- Constant voltage, usually in the form of tape, usually 24V but also seen as 12V and 48V. Sometimes there is a current limiting IC that gives equal brightness across a range of voltage. These are a bit less efficient than constant current devices. They can operate with no flicker at all at full brightness, and they can be PWM-dimmed. Trying to dim them by reducing voltage gives very inconsistent results.
The type of LED used has surprisingly little to do with how fancy or expensive a fixture is. Constant current drivers tend to show up only in fancier fixtures, but plenty of extremely expensive fixtures use awful light sources.