From a former call-center phone operator, I think the 10 1-sec pushes, is just a way to make sure the customer presses the buttons long enough. In our callcenter we often had to ask customer to hold the reset button on their router for 3 seconds. When the router didn't reboot, I would send replacements, until a colleague advised me to tell customers to hold the button for 10 seconds. Apparently when you ask customers to hold the button for 3 seconds, some will actually only hold it for 1 or 2 seconds. Suddenly most customers were able to reset their routers.
You are correct. When I am talking to people I usually tell them to hold it for 20 seconds and then state it's longer than it feels, so keep holding, and that USUALLY gets them past the ten second mark. Or I'll say hold it down and I'll tell you when to let it go. The power button itself isn't even REQUIRED but speeds up capacitor discharge. Once you disconnect the battery you just need all flea power to stop because Lenovo keeps some circuitry alive 24/7. Holding the power button helps complete the circuit and drain flea power fast.
When I worked at a call center, we would ask them to switch the ends of the Ethernet cables just to make sure they were fully unplugged and plugged back in.
The article says 10 pushes at 1-second intervals, which can each still be a very short push. Otherwise, yes, better press a little too long.
Just like you never ask them if something is plugged in, because the response you’ll get is “of course it’s plugged in, I’m not an idiot!” But they won’t actually check if it’s plugged in.
Instead, you ask them to check the wires because “sometimes they get loose”. In that context, they’ll check, and might see they forgot to plug it in. They’ll plug it in, but will only say “it’s working now” without telling you that they forgot. It’s fine because now the problem is actually solved.
Somewhat related - I asked Opus to add a 120 second timeout to LLM gateways. When I went back to inspect the code, I noticed it added a 10 seconds buffer, or n+10 seconds total timeout.
I wonder if these customers started counting seconds at one instead of zero.
We did similar.
"I need the serial number for your power supply. It's printed on the plug between the two prongs. Remove the socket from the wall and read me the number printed between the two prongs"
We only used that when we knew you were lying about having already restarted it.
“Unplug the power cord from the wall and blow on the prongs three times.”
This just saved my Lenovo Legion laptop! :) My gf dropped it a few days ago, and it hadn't booted since. I had already tried the static discharge procedure, but it didn't work for some reason. After reading your comment, I figured I'd give it one more shot, and it finally booted up. Thanks a lot!