logoalt Hacker News

coryrc • yesterday at 7:53 PM • 2 replies • view on HN

> Long lines are often DC.

There are only a few dozen HVDC lines in the USA, so that is inaccurate.

It is far more likely for a NEW long-distance line to be DC compared to the existing installation base.


Replies

SAI_Peregrinus • yesterday at 9:17 PM

To briefly describe why:

Current flowing through a conductor produces heat. This scales quadrtatically with the current, and linearly with the resistance. The resistance depends on the cross-sectional area of the conductor and its length. Long wires have more resistance for the same size of wire.

Transformers can raise the voltage & lower the current, or the opposite, in direct proportion.

So you want long-distance transmission to use the highest voltage and lowest current possible, so that the least amount of power is wasted heating up the wires, and so that you don't have to have ridiculously thick wires.

Transformer efficiency rises with frequency. Standard AC grid frequency is quite low, <100Hz everywhere in the world. For small scale utility transformers that's not a big problem, but for transmitting a lot of power the transformer efficiency matters much more. When a transformer heats up that heating happens all throughout it, but heat only dissipates on the surface, so bigger transformers get harder & harder to cool.

Recent (last decade or two) advances in semiconductor design has enabled some really big transistors which can switch a heck of a lot of power very quickly. Switching DC power on & off to create a square wave creates enough changing current that transformers can use it. Transformers don't strictly need AC, they just need changing current through them.

So it ends up being more efficient to convert AC from generators to DC, switch it on & off really fast to create a really high frequency square wave, run that through a step-up transformer designed for that high frequency, and smooth the result out with some big capacitors to clean up the DC. Then that high-voltage DC can be transmitted with relatively low losses on relatively small cables, and go through a similar process to convert down to low(er)-voltage AC at the receiving end.

That wasn't possible until recently, the transistors to switch that much power fast enough didn't exist. Thus the existing grid mostly being AC, with HVDC preferred for new lines.

bluGill • yesterday at 8:13 PM

There are very few really long lines in the US. There are a lot of lines that cross a state or two, but no farther. AC works just fine for those. When you are crossing China, the US (or any continent) DC becomes much better, but most lines are not nearly that long.