logoalt Hacker News

AkBKukU • today at 1:31 PM • 1 reply • view on HN

I have two alternate observations, because VGA is an analog signal there are standards for what the voltages should be. But they were not always followed. Keep in mind that the first two Voodoo cards were also video switchers with a chip to output either the 2D passthrough or the internally generated 3D chip signal created by its own GENDAC.

1. I have a Voodoo 2 paired with an S3 Virge/DX, the Voodoo 2 output level is lower. On a CRT I always have to make the image brighter when running a 3DFX game. Additionally, the V-Sync pulse is not the same as the Virge/DX and the Voodoo 2 image is shifted up.

2. I have a Voodoo Rush which is the maligned hybrid model of 2D and 3D chipsets on a single card. It still uses the internal switching though. On this card the voltage issues are the opposite, the 2D output is significantly dimmer than the 3D which makes the 3D game clip badly when running something until the image is adjusted again.

These problems are voltage level issues with the signal, not gamma. Adjusting gamma will not change the black or white voltage level of the signal. But a lower voltage signal may seem brighter as gamma is raised and the dynamic range is compressed.

> we were so enthralled by the absolute performance of 3DFX that the color fidelity didn’t get as much attention as it should have.

I would say it's more likely that they just didn't notice and the varying outputs from different 3DFX cards, with different GENDAC's, on differently calibrated CRTs just made it a total mess to try and and dial in something as imperceptible as a gamma level. Also keep in mind that around 1995-1996 adjusting the brightness of a CRT was as easy as twisting a few knobs on the front of it.


Replies

seritools • today at 3:19 PM

[dead]