From the article
> It was thought the UK had largely escaped such hacks as the British refrigeration industry relies on different devices but there was in fact a potential vulnerability the sector has been rushing to fix.
> In late October, security researchers discovered a major flaw that, if found by hackers, could have led to even worse damage to the UK.
Having worked with industrial equipment like this that often had some kind of network interface retrofitted to a 20+ year old device; I am going to guess it was a manufacture default master password that can be used to remotely manage/reset/reprogram the device and that essentially all deployed units never changed/disabled it.
In fact it may not even have been possible to disable or change it. It is scary the number of appliances, both industrial and consumer, that have "secret god mode" reset passwords and also just happen to work remotely..
Now to defend the manufactures a little bit here these master passwords were originally used because these devices didn't have any kind of network connectivity at all when they were originally design back in the 90s (or perhaps even earlier).
They were there for an engineer to come along, plug in an RS232 or similar and they could use the master password to just fix whatever was wrong. Then over time either networking/internet functionality was added via an additional interface (such as a master control unit all machines were connected to and then that MCU had network/internet access but essentially acted like an unmanaged network switch and just passed on whatever it was sent) or directly to the system in a new model revision.
However nobody deals with the whole master password part and so you end up with a warehouse or supermarket freezer that is now on the internet and if you're lucky "protected" by CG-NAT (usually that is the best case, rarely do you see any real network security in these setups) with essentially a remote login that all use the same password.
Of course this is just a guess from my own experience but if I were a betting man that is where I would put my money.
As for the "security researchers discovered a major flaw" I would also guess this flaw has been known by the manufactures since forever but it was security through obscurity as few people knew of a master password or how to use it.
However most likely aided by LLMs some researchers just dropped in firmware blobs from industrial systems they started looking at after the hacked systems in France in the summer and the LLM did what they do extremely well and find these things.
This set off the alarm bells and the NCSC got involved as a national security concern and thus begins a quiet but rapid call to mitigate the issue before someone else discovers it.
The article does say (admittedly from the manufacturer) that to exploit it required getting a device and taking it apart, so maybe they did just dump this password from the firmware.
Perhaps I'm being a bit too charitable, but surely if the password is indeed just one single root master password, once it has leaked, its leaked for good and so there's no need to get hold of a device. Or someone could have brute-forced it to begin with...
This has got me wondering if my alarm system; which is connected to my network and has a cellular backup is a lovely hackable bridge with default password 0000.
No. It was these people
* https://omega-solutions.co.uk
who went actively looking for problems having seen the Danfoss incidents. More detail is in the Pen Test Partners press release (q.v.).